| Subject | Text |
| SONY STR KSL5 Protect Fault | I have a SONY STR KSL5 home cinema system which after about 5 mins shuts off with the word "PROTECT" |
| Oh..
.. ok thank you, Mel.
The only flat faced crt's were Sony Trinitrons when I was an active |
|
|
| Samsung CB21H1T,S15a | I have a problem with TV Samsung cb 21h1t,power is dead,voltage 300v is present,but stand by is not |
| Samsung 191t power problem | The Unit will power up but intermittently the unit will power cycle. this appears to happen only wh |
| Here's the parts that I used:
[url=R509 100K Ohm 1W resistor[/url] - got an set on Amazon. I prob |
| yeah! tv still working but, always need to push the reset button in front. otherwise no signal with |
| repairing an old sansui amplifier | hello every one ,
new member here and also newby in the electronic repair
i have an old sansui |
| Transistor question if you know electronics please help! | I need to replace a couple transistors and I have the numbers but don't know where to purchase them |
| building a generator | how do I use a standard 240v single phase ac motor driven by a petrol engine to create 240vac betwee |
| Ok made the check. At first I was not sure I could call up the counter. Not sure how I did it but no |
| Dead Black Diamond BD28WS | Hello to everyone this is my first post here. I have a BD28WS Black Diamond TV. The fault is when I |
| Looking for Pioneer VSX-D307 Receiver Service Manual | I'm looking for a service manual (or at least a schematic) for my Pioneer VSX-D307 Receiver.
Anyo |
| voltage for relay | hi,i have a problem on my yamaha rx-v392 model...i need to know what is the voltage of the relay in |
| Can't remember. Isn't it in Admin tools, domains and trusts or something?
Do you have Active Direct |
| thank you for your replies
the original power supply died some years ago, and i have bought a 1000m |
| H/K AVR 25II - protect mode only with center channel | Hi,
First thanks for the tech manual/schematics! Wonderful start. I can sort of read schematics a |
| Re: Onkyo TX-SV535 Amp / Remote Speakers NOT Working | [quote:586d3411be="kayecross"]I can not get the remote speaker button to work on my amp. I have inst |
|
|
| Hi again,
By bypassing the main speaker relay everything works great. Does anyone know if this mi |
| avr 130 one of the surround outputs is very very low | got a harman kardon avr 130 one of the surround outputs is very very low
when i connected speaker t |
| need schematic for alesis m1 monitors | I'm willing to pay for alesis m1 active monitor schematics. Any takers? |
| [quote:960ed3bfcc="pinoyeagle"]Thanks Phils and minnie.
I just found what the problem is. It's a |
| I think you should first check for bad electrolytic caps in the power supply. Usually, but not alway |
| Re: Do this test | Forgot to mention: Keep CD player's volume quite low to keep from exceeding input level rating of yo |
| Protect mode occurs when an overcurrent situation is detected by the power supply in the amplifier. |
| Headphone circuit for TV needed. | Hello all. I hope this is the right place for my question. Ok, I have a infrared wireless headphon |
| TV | DEAR SIR
MY TV INDIA BRAND VIDEOCON MODE : 29PJWM FLAT TV , ONE TIME MY TV PCB CIRC |
| A/V Tech Wanted - NYC/Brooklyn | Looking for QUALIFIED service technician to handle repairs of audio & visual equipment in the Br |
| Event Monitors | Hello!
My Event 20/20 are not working anymore, I have tested both speakers and seem to work fine, s |
| Blowing speaker protection fuse suggests failure of the power amplifier output transistors. If a DVM |
| Hi,
Few things u can check:
1. Does the set power up?
2. Speakers - are they connected prop |